Rear lower arm bolt, PN 90167-S30-000 - BOLT

Brozilla · Post by **Brozilla** » Tue Jul 21, 2020 8:14 am

While stripping the suspension from my 5th gen down, both bolts for rear lower arm were lost during galvanization and I am in need of them.
I ordered new ones, but they are out of production, here is the chart where they belong:
https://www.amayama.com/en/part/honda/90167s30000

If someone has 2 spares, I would like to buy them off.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Tue Jul 21, 2020 10:15 am

Can't help unfortunately, other than to sympathise.
Rear Lower suspension arm bolts are a right pain - they've always getting seized solid and ruined during removal. We're seeing more and more people asking for good used spares, because they're not available new

Brozilla · Post by **Brozilla** » Tue Jul 21, 2020 11:09 am

Thanks for the heads up, I am pretty sure a bolt on my CR-V is the same. CR-V one is not out of production.
I wanted to see if someone has an original one first. I guess I will order the CR-V one and see if it fits.

Post by **Vtecmec** » Tue Jul 21, 2020 12:12 pm

I think the parts catalogues (or the manual, cant remember fully) give you the dimensions of the bolts, you can cross check this across other hondas (or elsewhere) to get something that fits.

Brozilla · Post by **Brozilla** » Tue Jul 21, 2020 12:43 pm

Yeah, it is 14x77 mm

Post by **vanzep** » Tue Jul 21, 2020 1:16 pm

Dont know if it is of any help but the 4th gen suspension bolts i have here are all 12mm diax83mm or longer - these are the ribbed ones

only 14mm dia bolt i can see is the camber adjustment bolts for 4ws but they are about 83mm long as well....

Brozilla · Post by **Brozilla** » Tue Jul 21, 2020 1:48 pm

Thanks vanzep, but the ones I am looking for are not ribbed. And that is exactly the reason why they seize in the bushings. Sneaky

Post by **ek9sid** » Tue Jul 21, 2020 3:59 pm

https://www.parts-honda.uk/honda-cars/P ... 00/4/25559

This shows as being available

DanishLuder · Post by **DanishLuder** » Fri Jul 24, 2020 7:12 pm

vanzep wrote: ↑
Tue Jul 21, 2020 1:16 pm
Dont know if it is of any help but the 4th gen suspension bolts i have here are all 12mm diax83mm or longer - these are the ribbed ones
only 14mm dia bolt i can see is the camber adjustment bolts for 4ws but they are about 83mm long as well....

Those bolts, washers and nuts on the last picture, can I buy those?
Pretty sure thats the ones i desperately need!

Post by **vanzep** » Fri Jul 24, 2020 10:00 pm

sorry DanishLuder ive got to keep them for when i fit the new polybushed rear lcas and trailing arms
last time i went for a wheel alignment they could not adjust these bolts on one side as it was seized in the bush so camber is out 1 degree as a result