Little update on this…
I gave the interior a good clean removing all the seats to do so and wet vacuumed the floor mats..
This is the dirt and grime present before hand..
There was literally an ants nest under the back seat and nearly 30years of grot down the side of the seats
Sadly I didn’t take any of the results as I’ve been abit busy..
I’ve also had a nasty knocking noise which has been getting worse, a good spanner check of all engine mounts, suspension arms and subframe bolts found many to be not as tight as they should be and after tightening everything the knock has gone..
Also got the SRS light to go off with a 2.2ohm resistor loom made up and a dodgy home made service reset tool for clearing the code..
Congratulations to vtecmec for winning May/June's Lude Of The Month, with his DIY Turbo BB1 build.
>>> Click Here For Profile <<<
>>> Click Here For Profile <<<
JEBB4’s Prelude BB6 SiR
- JEBB4
- Supporter 2014
- Posts: 1239
- Joined: Tue Feb 18, 2014 7:28 pm
- My Generation: 5G
- Location: Australia
- Has thanked: 89 times
- Been thanked: 75 times
JEBB4’s Prelude BB6 SiR
My BB6 buildJamie P 2013 wrote:i like tits
viewtopic.php?f=17&t=54187
My BB2 build (yang)(WRITTEN OFF AND SOLD)
viewtopic.php?f=17&t=18866
My BB4 build (yin) (SOLD TO DRAX)
viewtopic.php?f=17&t=12087&hilit=JEBB4+ ... ty#p203321
- wurlycorner
- Ye are glad to be dead, RIGHT?
- Posts: 21383
- Joined: Sat May 19, 2012 3:33 pm
- My Generation: 4G
- Location: Chelmsford, Essex
- Has thanked: 2257 times
- Been thanked: 282 times