Wiring help 5th gen auto to manual using manual ecu with auto harness

Luder850 · Post by **Luder850** » Fri Apr 07, 2023 8:05 am

Can't get it to turn over but when i crossover the starter it will crank but wont start. Not sure about clutch pedal wiring

Post by **Vtecmec** » Fri Apr 07, 2023 9:28 am

What have you done with the wiring where the gear selector used to be?

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Thu Apr 13, 2023 2:45 pm

On an Auto, the circuit looks to check that the shift selector is in either Park or Neutral.
On a Manual, the circuit looks to check that you have the clutch pedal depressed (according to the US manual at least...).
Section 4-3 of the service manual.

Vtecmec's question is the key one - what wiring changes have you made as part of the swap from auto to manual?