Need a favour from a 3G owner!

becca · Post by **becca** » Tue May 12, 2015 8:01 pm

I need someone with a 3G to do me a favour

and measure
- their sills total length
- the length from the rear of the sill to where the rear of the door is
- the length from the front of the sill to where the front of the door is

I'm looking for some side skirts and I've found some nice ones for a 2G Lude but need to check for any differences, and things like end heights to see if the doors will foul them (there aren't any direct fit ones I can find for the Aerodeck). I do have some for an AE101 but they're quite a bit too short, it'd be nice to have something that's more of a direct fit / minimal modification.

If someone can help that'd be great, no real rush as my 'deck isn't going anywhere in a hurry

Thanks

*revised from 2G to 3G

Post by **NafemanNathan** » Tue May 12, 2015 10:14 pm

@B00mer
@jjmartin3495718723457623457623802340892308700283723450234
@Rob_Cool1

'92 Si VTEC · Post by **jjmartin349571** » Tue May 12, 2015 10:25 pm

I was going to poke my head up, but I'm a bit embarrassed by the fact that I've currently got spider problems in the garage

I'll bust out the hoover at some point and once I've reclaimed my territory I'll try and take some measurements, however my sills are in a sorry state so there's a good chance they aren't the length they should be

Rob_Cool1 · Post by **Rob_Cool1** » Tue May 12, 2015 10:26 pm

Il be back on the weekend if I get time il have a look, I got y of that r32 gtr skirts are pretty much the same size, but il measure when I can

Post by **NafemanNathan** » Tue May 12, 2015 10:37 pm

jjmartin349571 wrote:

I was going to poke my head up, but I'm a bit embarrassed by the fact that I've currently got spider problems in the garage I'll bust out the hoover at some point and once I've reclaimed my territory I'll try and take some measurements, however my sills are in a sorry state so there's a good chance they aren't the length they should be

bb1boy · Post by **bb1boy** » Fri May 15, 2015 1:20 pm

NafemanNathan wrote:@jjmartin3495718723457623457623802340892308700283723450234

B00mer · Post by **B00mer** » Mon May 18, 2015 10:51 pm

Just read this sorry for late reply, my lude is stashed away in a local council garage.

Ill pop by one of the night and break the tape out for you no problems

B00mer · Post by **B00mer** » Fri May 29, 2015 1:17 pm

Ok becca

Sills...

Full length 66 inches
Rear to rear of door 11 and a half inches
Front to front of door 7 inches

Hope this helps,

B00m.

becca · Post by **becca** » Mon Jun 01, 2015 6:40 pm

So I've just done a measure up and it's probably a no go

Full length 75 and 3/4 inches
Rear to rear of door 18inches
Front to front of door 4 and 3/4 inches

Back to the drawing board then

Really struggling to find anything long enough that's also era correct (i.e. not bubbly shaped, something angular instead)