3gen ALB light help!

91pREluDe · Post by **91pREluDe** » Sun Oct 02, 2022 2:49 pm

Hi guys i am having a problem with alb. As i start to drive, my abs pomp under the hood starts to buzz and after couple minutes it stops and ALB light comes on. I was trying to see the code and it blinks 3 times. Well any help would be appreciated

Scott560 · Post by **Scott560** » Sun Oct 02, 2022 6:59 pm

Found some useful information here:

http://prelude3g.com/p3g/documentation/ ... lbcode.htm

it's likely if you watch the flash codes there are further codes which will help narrow down the issue.

Scott560 · Post by **Scott560** » Sun Oct 02, 2022 7:08 pm

3rd gen owners can comment further, but reading similar old honda ABS issues, it sounds like the ECU runs the motor to check for a build in pressure. Failed O rings stop the pressure building, so pump over-runs, then gives up and throws a code.

Is it possible you only have code 1 repeated 3 times?

91pREluDe · Post by **91pREluDe** » Sun Oct 02, 2022 8:47 pm

Hi again it looks like it's a code 1 as after removing fuses it blinks just once

91pREluDe · Post by **91pREluDe** » Sun Oct 02, 2022 8:52 pm

It looks like I will have to bleed the alb high pressure fluid and I will need a ABS T Wrench, that can't find to buy